G250 - Overlapping Articulating Gauntlet

 

 

Custom congruent to patient using:
Plaster, STS, Fiberglass Roll, 3D Scanner, Existing Positive Model
Current timing for delivery is 3 weeks.
Expedited on availability.

Suggested Codes
L1970

Plus the codes below
L2275, L2820, L2330 

Medicare DMEPOS Fee Schedule
Medical Compliance details

 


Clinical Indications:

  • Adult acquired flatfoot stage III & IV
  • Mild PTTD (Posterior Tibial Tendon Dysfunction)
  • Talocalcaneal varus or valgus
  • Mild to moderate DJD (Degenerative Joint Disease)
  • Ankle instability
  • Mild to moderate pronation
  • Mild to moderate supination
  • Trauma

Recommended For:

  • Patients who require stabilized subtalar, talocalcaneal, & midtarsal joints while allowing motion in the ankle

This brace is formed over a positive model of the patient’s foot. A negative impression or scan above the height of the finished brace must be created to correct and hold the foot, ideally with the ankle at 90 degrees and in a semi-weight-bearing or full-weight position. The finished device is crafted by pulling a leather lining over the model, followed by the plastic layer and a final sewn leather top cover.

This device is fully customizable per the practitioner’s discretion and is available exclusively through licensed medical providers.

Product Details

The Overlapping Articulating Gauntlet brace is ideal for providing hydrostatic control and limiting the range of motion in the ankle. A leather upper gauntlet wrap provides ankle support, and external lateral and medial struts are positioned on a joint to allow limited articulation. Its polypropylene shell is constructed just distal to the malleoli, so as the patient moves, the plastic will slightly bend while the stirrups reinforce and guide the ankle’s movement. Because of this device’s bulk, shoes with extra volume are required.

 

 

This brace is formed over a positive model of the patient’s foot. A negative impression or scan above the height of the finished brace must be created to correct and hold the foot, ideally with the ankle at 90 degrees and in a semi-weight-bearing or full-weight position. The finished device is crafted by pulling a leather lining over the model, followed by the plastic layer and a final sewn leather top cover.

This device is fully customizable per the practitioner’s discretion and is available exclusively through licensed medical providers.


SUGGESTED Codes

L1970 Ankle foot orthosis, plastic with ankle joint, custom fabricated


Plus the codes below

L2275 Addition to lower extremity, varus/valgus correction, plastic modification, padded/lined
L2820
Addition to Lower Extremity Orthosis, Soft Interface for Molded Plastic, Below Knee Section
L2330 A leather, or similar material, lacer molded from a model of the patient, that fits around the calf area, includes casting and cast preparation